Low flat screwdriver bits Tx15x165 and 175

As a manufacturer of screwdriver bits, we were approached by a printed circuit board manufacturing company with a very specific requirement. They needed two types of screwdriver bits with very special technical specifications. One of the bits had to be 165mm long and have a diameter of less than Ø3.68mm, while the 175mm bit could not exceed Ø3.75mm. This is a very important internal challenge because as a screwdriver tip with a small diameter, it is a very manual manufacturing process and the tip can be bent in the hardening process. This is why it is important to check and straighten each of the tips manufactured one by one. In the end, the manufacturing process has been a success, despite some challenges. Right now, thanks to the tips we have manufactured, there is a printed circuit board factory that is not standing still and produces parts with our products.